KISRAK-M1 Documentation
0.4mm Clearance Selection for Voltage Isolation
01 - Executive Summary & Project Motivation
02 - Detailed Hardware Architecture (Sub-Systems)
03 - The Physics of Dead-Time (Deep Dive)
04 - Signal Control & Firmware Interfacing
05 - DIY Fabrication & Reliability
06 - Test & Validation
Asymmetric Switching: Rise Time Delay vs. Fast Discharge Mechanism
Challenges of Single-Layer PCB Design & Ground Plane Strategy
Control Logic Table for MCUs
Cross-Conduction (Shoot-through) Risk Analysis and Mitigation
Driver Stage: Totem-Pole Gate Drive
Duty Cycle and Average Voltage Calculation
Gate Signal Analysis with Oscilloscope
Initial Power-Up Protocol (Smoke Test)
KISRAK-M1 Documentation
KISRAK-M1’s Micromouse Design Philosophy
Motor Driver Limitations in Robotics
PWM Frequency Selection: Why 8kHz - 20kHz is Ideal
Power Stage: MOSFET Selection and Thermal Efficiency
Protection Systems: Reverse Polarity and Inductive Kickback
RC-D Circuit Time Constant Calculations
Thermal Pad Design for Toner Transfer Etching
Why Discrete MOSFET Design?